[LA-SiGMA-LSU] Co-sponsored seminar by Steve Plimpton - Nov. 4 Sid Fuchs ME Seminar Series and LaSiGMA Seminar

[bthakur at cct.lsu.edu]

Dear Dimitris,

I dont think it would be possible to broadcast it as there are only  
few rooms equipped with Access Grid equipment required to broadcast  
seminars.
Having Polycom wont work either as most campuses in LI/LASiGMA can  
only connect through AG.

However we can setup an informal meet and greet with long-distant  
LI/LASiGMA faculty when he visits CCT in the morning. It is great that  
he will meet the GPU team here as we have been exploring GPU  
implementations of LAMMPS and will be able to discuss some aspects  
with him.

Regards,
Bhupender.


Quoting "Dimitris E. Nikitopoulos" <meniki at me.lsu.edu>:

> Dear Colleagues,
>
>
>
> I finally have a finalized travel plan from Steve Plimpton for his visit and
> seminar at LSU. I am writing to you directly because you had expressed your
> interest specifically when I had put out a call a few months ago. I am also
> copying all of our LaSiGMA colleagues to make sure that they are aware and
> have the opportunity to participate.
>
>
>
> His visit will start with a late arrival on Nov. 3. He will spend the whole
> day Nov. 4 at LSU and depart Nov. 5 early in the morning. His seminar will
> take place 3:30pm-4:30pm, Nov. 4 in the Frank H. Walk Design Presentation
> Room (ELAB 140, directions will be sent to all).
>
>
>
> Steve has a very busy schedule so he will be here one day only (I was
> angling for two, but did not work out), so an effort will be made to make
> his short visit as meaningful as possible for as many as possible.
>
>
>
> I believe it is fair to give priority of participation to the co-sponsoring
> entities (Mech. E. and LaSiGMA), so I will not broadcast the event to the
> wider public until next Tuesday. I will send out a flier with Steve's
> abstract to ME and LaSiGMA personnel later today.
>
>
>
> My thoughts on the schedule and arrangements are given below the signature
> line of this message. Please provide your feedback so that we can converge
> sooner rather than later.
>
>
>
> Best
>
> Dimitris
>
>
>
> Schedule
>
> 1.       Multi-scale simulations and tool development group
> (coarse-graining, continuum-MD/DPD, etc.); Venue: Venue: 338 Johnston Hall
> (CCT); Time Slot: 8:30am - 9:15am
>
> 2.       GPU group; Venue: 338 Johnston Hall (CCT); Time Slot:
> 9:30am-10:15am
>
> 3.       General LAMMPS interested group; Venue: Venue: 338 Johnston Hall
> (CCT); Time Slot: 11:00am-11:45am
>
> 4.       Lunch with up to 6 interested Faculty (TBD); Venue: Faculty Club;
> Time Slot: 12:00noon- 1:15pm
>
> 5.       Meetings with individual interested faculty (TBD); Venue: PFTH;
> Time Slot: 1:30pm - 3:00pm
>
> 6.       Seminar; Venue: Frank H. Walk Design Presentation Room (ELAB 140);
> Time Slot: 3:30pm - 4:30pm
>
> 7.       Graduate Student and Post-Doc. Social; Venue: Frank H. Walk Design
> Presentation Room (ELAB 140); Time Slot: 4:30pm - 5:30pm or 6:00pm
>
> 8.       Dinner with Mark Jarrell (or designee), Nikitopoulos and up to 4
> more interested Faculty (TBD); Venue: Juban's or Mansour's; Time Slot:
> 7:00noon- ...
>
>
>
> Organization
>
> Those who wish to drive in from other towns (e.g. Ruston, New Orleans)
> should be provided with hotel accommodation free of charge.
>
>
>
> The Walk Room will be used for the seminar because of its holding capacity
> (~120+ ) and presentation infrastructure. I call on Bhupender Thakur to work
> with our technical staff to make arrangements over next week and ensure that
> the seminar is broadcast live to our LaSiGMA partners, who should also "beam
> in".
>
>
>
> 338 Johnston Hall will be used for the group meetings because it is very
> well equipped for highly interactive smaller meetings involving individuals
> at remote sites. I call on Bhupender Thakur to work with CCT technical staff
> to make arrangements over next week and ensure that the remote connections
> are properly set up and working.
>
>